Air Craft Modle

DESCRIPTION OF AIR-CRAFT (SYSTEM): remote control.

1-General preface: Machine indicated on above picture is described on following four categories:

A: Internal.

B: Middle

C: External

D: Security

This part consists of six strong turbojet engines( triple type)

with side air causing situated on an icosahedral skeleton fabricated of strong light metal.

A perpendicular axial shaft from top directed towards bottom(earth centered) rotates and is fortified by two gear-disks covered by tow impellers and placed on upper and lower sides of a central diffuser.

2 Five supplementary sides-shafts with axis to axis distance of 72 degrees from each other and 45 degrees distance from horizontal and vertical planes are trapped in a gear disc of 360 degrees from one end and exit through icosahedral along bisector of (*/- X,Y) planes on the other end.

All compressors are positioned on upper part of icosaheral and combustion chambers plus turbo on lower partes of apparatus.

Central diffuser and impellers are covered by a glob assumed to be primary..

shell which connected internal case of compressor and turbo to each other and compresses air into combustion chambers it pass through exhaust and around of nozzles after combustion.

B. Compressed air of compressor is considered to create high thrust lift and cools combustion chamber casing and exterior shell of turbo after passing through different parts.

sections enters(second glob) shell and after cooling exterior casing of combustion chamber together with hot air through exhaust exits and enters semi balloon.

Note in middle section where an icosahedral is situated as a load carrier of six turbojet engines ,electronic distributor feeders of sliding blades and pulleys are placed.

Carrying upper and lower bearing cables and security net is placed sixty blades of double detached sliding casing in pieces with axis to axis distance of six degrees.

Compressed air stenches sliding blades together with balloon and balloon hangs compressed-air-pipes extracted out of blades and as soon as compressed air stops springs of pulleys pull sliding blades backwards.

C: Exterior From ten compartments or chambers.

there are five upper chambers and five lower compartments:

l) Electronic Generator.

2) Battery chamber.

3) Regulator of fuel, air belongings.

4) Remote control system.

5) Liquid coolant chamber and hydraulic pump.

This machine sits on five base-legs(wheels)indicated as below

and balance its weight they fold after air-craft has taken off, it operates by hydraulic system.

2-METHOD 0 MACHINE OPEATION:

starts by compressed air after ignition in its combustion chambers and reaches either on low or high level positions and stretches its blades on space like this

starts absorption of fog or cloud by elector-refrigeration and expands its

volume.

Inside blades casing thermo-couples are located and have joined each other parallel and create both cool and warm systems according to the order of pilot

or remote control.

Blade casing pieces join each other by terminals.

Air craft weight on space is lifted by its engines and supported by warm air-balloon from exhausts. For Favorite directions upper compressor air-enter-case turns a small angle on favorite coordination more air is compressed to inner tubes out of elector refrigerator blades. Consequently balloon\rquote s lower sides stretch and a holed skin upper part creates head of ballo on by changing positive and negative positions of thermos-electric refrigerator blades shower starts to fall as soon as duty of machine is over.

Both and blades return to their initial positions, then air craft lands and system is turned off.