Retail Lighting Fixtures wanted

PRODUCT DESCRIPTION

Slope ceiling TC Housing designed for use in non-insulated areas

If installed where insulation is present, the insulation must be

pulled back 3 from all sides of the TC housing.

PRODUCT SPECIFICATIONS

Lamp

Lamp ratings based on trim selected see reverse.

Socket

Medium base porcelain with nickel-plated copper screw

shell Adjustable to position lamp perpendicular to floor.

Trims

Trim selection shown on reverse.

Labels

U.L. listed for through-branch wiring, damp locations and

IP Product thermally protected against improper use of lamps or

insulation Union made AFL-CIO UL Listed/CSA certified Trim

No. 610 is wet location approved for covered ceiling

applications.

Testing

All reports are based on published industry procedures;

field performance may differ from laboratory performance.

Product specifications subject to change without notice.

INSTALLATION

Real Nail 3 Bar Hangers

Telescoping, patent-pending Real Nail 3

system permits quick placement of housing anywhere within 24

O.C. joists or suspended ceilings Integral T-bar notch and clip

secures housing in suspended ceiling grid no accessory clips

required 24 expansion stop allows quick placement of fixture

in standard grid spacing Bars scored in two locations for fast,

clean breaking, allowing housing installation in tight applications

Bars captive to mounting frame Edge-mounted for extra

strength Captive bugle-headed ring shank nail for quick one-step

installation and easy removal with claw hammer for fixture

relocation Quick-Loc slot and oversized locking set screw lock

fixture in position Bar hanger foot contoured to align to bottom

of construction joist Alternate mounting holes included.

Junction Box

Pre-wired junction box provided with (5) 12 and

(1)

34 knockouts, (4) Non-metallic sheathed cable connectors and

ground wire, U.L. listed/CSA certified for through-branch wiring,

maximum 8 No. 12 AWG 90� C branch circuit conductors (4 in,

4 out) Junction box provided with removable access plates

Knockouts equipped with pryout slots.

Mounting Frame

22-gauge die-formed galvanized steel

mounting frame Rough-in section (junction box, mounting frame,

housing and bar hangers) fully assembled for ease of installation.

Housing

TC housing, 22-gauge white painted steel with

aluminum cap Housing is vertically adjustable to accommodate

up to a 1 ceiling thickness Designed to fit 2x8 or 2x10 construction.