oven wanted

Oven construction: The oven walls, ceiling and roof are made of 20 gauge or thicker steel that has been aluminized or G90 galvanized. The oven utilizes a double panel design. The interior walls and roof are formed into 6?panels to receive factory-supplied insulation. Mineral wool insulation of at least 6# density is inserted between these inner panels and the external skins during installation. The main oven enclosure components are bolted together, typically on 6?centers. Threaded inserts in key parts help simplify assembly. When using roof mounted heat units or double load-in frontals, the ovens are equipped with support beams to increase rigidity. No welding is required.

Doors/Frontals: The oven doors are a composite design made of 16, 18, and 20 gauge components that house mineral wool insulation of not less than 6# density. The doors feature support casters and adjustable hinge assemblies. To assure proper explosion relief and allow for emergency egress, the doors include a positive latching device that secures one door to the frontal header and floor, and allows the second door to latch to it using friction latches. Friction latches, often known as anic latches?or lam latches?enable the doors to be opened from the inside and also serve to safely vent excessive positive pressure from the oven enclosure. Doors feature fiberglass gasket material to minimize heat loss.

Heat unit: The heat unit is constructed of primarily 11 gauge, 16 gauge and 18 gauge stainless, aluminized or G90 galvanized steel components with mineral wool insulation of 6# density used throughout the assembly. The heat system utilizes an ETL-listed et Fire?forced-induction burner with an integrated combustion supply fan. The heat unit adjusts n the fly?in response to the control panel PID fuzzy logic controller. The heat unit enclosure includes a forward curving fan wheel to cycle the heated air through the oven enclosure. The heat unit features an oversize fan shaft for durability and reduced vibration, as well as special high-temperature bearing assemblies that are easily accessible. Each unit is optimized for premium results at the customer location and shipped with a fan performance graph.

Controls: The heat unit is controlled via a remote control panel. This control panel allows the operator to see a digital display of the heat unit output air temperature and adjust the unit accordingly. The control system uses a variable frequency device (VFD) to adjust the atmosphere inside the oven by fine-tuning the performance of the exhaust fan. The control panel also includes a variety of safety devices, including audible and visual alarms.

Safety Features: The oven is equipped with a range of redundant safety devices. These devices include:
?High and low pressure gas safety valves
?Manual gas shut-off
?Ignition sensor with auto shut-down
?Combustion safeguard
?Flame safety switch
?Powered air circulation fan
?Powered air exhaust fan
?Intake air proving switch
?Exhaust air proving switch
?High temperature safety switch
?Oven temperature sensor
?Purge timer for combustion
?Purge timer for oven operation
?Motor overload protection
?Fan/belt/motor guards
?Explosion relief design
?Audible & visual alarms on control panel