Variable Frequency Drive Motors

1) Operation Source Switch

Run command/frequency source are easy to select with a DIP switch. Default is keypad settings. Sliding

the switch changes the sources to the control terminals.

2) Improved PID Control

Reverse PID function changes the sign of the deviation value which is the difference between target and feedback values.Upper and lower limits from a target value can be imposed on the inverter output frequency.

3) Logic and Output Timing functions

Output terminals can be assigned logical operators AND, OR and XOR with RUN, AL and so on. ON and OFF delay times are settable for each output terminal. Allows for more flexible system design.

4) Analog Setpoint Calculate Functions

An offset frequency can be added to or subtracted from the output frequency when ADD terminal is ON. For example, if output frequency setting is 40Hz and offset frequency is 5Hz, output frequency becomes 45Hz (or 35Hz) when ADD terminal is ON.

5) Integrated EMC Filter Versatile Functions

Global Performance

Conformity to global standards. CE, UL,c-UL and c-Tick approvals.

Pure analog monitor output (8-bit, 0-10V DC)

External thermistor terminal (PTC)

Side-by-side installation

Second motor setting

Over-voltage suppression at deceleration

3-wire control

Analog input selection

Second acceleration/deceleration setting

Jogging

Unattended start protection (USP)

Analog input wire-break detection

6)RS-485 Serial Port

An RS-485 communication port with Modbus®-RTU protocol is integrated. Easier for network operation.

7) Versatile Functions

Pure analog monitor output (8-bit, 0-10V DC)

External thermistor terminal (PTC)Side-by-side installation Second motor setting

Over-voltage suppression at deceleration 3-wire control Analog input selection

Second acceleration/deceleration setting Jogging Unattended start protection (USP)

Analog input wire-break detection