|Place of Origin:||
AC Three Phase
1500 / 1800 rpm
50Hz / 60Hz
220-380V / 240-415V
open type generator,
powered by Volvo engine
Generator 300KVA at prime, 3 phases
Good quality diesel genset
SPECIFICATION OF GENSET MODEL HT5V30
HUUTOAN genset model HT5V30, powered by VOLVO diesel engine model TWD941GE (Sweden) driving a Mecc Alte alternator model ECO 38 – 2LN/4 (Italy).
HT5V30, Soundproof Canopy (Optional).
+ Rated output at standby
+ Rated output at Prime
Class H with tropicalization
+ Power factor
cos j = 0.8
+ Rated voltage
Dimensions (mm) ( Open)
- Length: 3900
- Width: 1400
- Height: 1950
Dry weight ( kg) ( Open)
+ Fuel consumption (L)
- 36.8 liters ; at 50% load
- 52.6 liters ; at 75% load
- 70 liters ; at 100% load
+ Total fuel tank
+ Total lub. Oil capacity (L)
The engine and alternator are coupled directly with each other and mounted on a base frame.
Gen-set is designed for intermittent overload capacity of 10 % for one hour in any twelve hours of running at prime rating. Standby power ratings are applicable for supplying electric power in event of normal utility power failure. No overload capacity is available for the standby ratings.
engine model TWD941GE
In-line cylinder, 4-cycle water-cooled diesel engine
Turbocharged after cooled
Bore x Stroke
120 mm x 138 mm
Radiator as standard, oil cooler, Drain Tap
Electric starting motor, battery charging dynamic with the voltage regulator, recharged with protection cover the battery.
Exhaust system includes the following items such as flange and counter-flange exhaust silence, stainless steel flexible joint to connect the engine outlet with the exhaust pipe. Engine is protected against low oil pressure, high engine temperature, over-speed.
300 KVA at prime
Mecc Alternator model
ECO 38 – 2LN/4
Bushless, self excited with AVR, single bearing, direct coupled.
Single bearing, self lubricated, self ventilated.
The voltage accuracy is +/-1% in static condition with any power actor and speed variation between -5% - +30% with reference to the rate speed.
The materials used for the manufacture of the mechanical structure are the following: FeP12 steel for the frame, C45 steel for the shaft and cast iron for the end-brackets.
The permissible overloads are of 300% for 20 seconds, of 50% for 2 minutes and of 10% for 1 hour every 6 hours of operation.
Insulation and impregnation
Insulation is of class H standard. Impregnation is made with tropicalized epoxy resin by dipping and dripping, whilst for the high voltage parts by vacuum, so that the insulation level is always very good.
the self-regulation is obtained through an electronic
regulator. The regulator is fed by an auxiliary winding which guarantees an almost constant supply any possible operating condition of the generator. The alternator is equipped with S.R7 regulator, ensuring its performance.