All kinds of LED driver
1, 100% Full Load Burn-in Test
2, TUV CE UL Rohs
3, +2years warranty
4, Welcome inquiry
we can supply complete series of LED power supply,1-600w,constant current,constant voltage,dimming,RGB controller and more.Welcome your inquiry!
CONSTANT CURRENT OPERATION VOLTAGE Note7
0 ~ 1.5A
0 ~ 0.75A
0 ~ 0.5A
RIPPLE & NOISE (max.) Note.2
VOLTAGE ADJ. RANGE
CURRENT ADJ. RANGE
VOLTAGE TOLERANCE Note.3
SETUP, RISE TIME
1500ms, 30ms / 230VAC
HOLD UP TIME (Typ.)
50ms/230VAC at full load
180 ~ 264VAC 254 ~ 370VDC
47 ~ 63Hz
AC CURRENT (Typ.)
INRUSH CURRENT (Typ.)
Cold start 50A/230VAC
0.25mA / 240VAC
Above 105% rated output power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
41.4 ~ 48.6V
Protection type : Shut off o/p voltage, clamping by zener diode
Tj 170 t ypically (U1) Detect on main control IC
Protection type : Hiccup mode, recovers automatically after temperature goes down
-30 ~ +70 (Refer to output load derating curve)
20 ~ 90% RH non-condensing
STORAGE TEMP., HUMIDITY
-40 ~ +80 , 10 ~ 95% RH
0.03%/ (0 ~ 50 )
10 ~ 500Hz, 2G 12min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY &EMC(Note 4)
TUV EN60950-1, IP67 approved; design refer to UL1310 Class 2,EN61347-2-13, CAN/CSA C22.2 No. 223-M91
I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH
EMI CONDUCTION & RADIATION
Compliance to EN55022 (CISPR22) Class B
Compliance to EN61000-3-2 Class A, EN61000-3-3
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, Light industry level, criteria A
1200.6K hrs min. MIL-HDBK-217F (25 )
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
With a strong vision of human's future, we have been devoted to the development of green, energy saving and environmentally friendly products in the line of LED, PV,power supply design and manufacture since the establishment in 2006. Hangzhou GM New Energy Tech Co., Ltd. has two factories: one is located in Hangzhou and the other is located in Shenzhen. Our factories totally cover an area of 17, 000 square meters. We have 8 assembly lines and over 500 workers.