1.Products Characteristics: The material of SS5002 is the RTV-2 pouring sealant. Its characteristics are below:Excellent in high-low temperature resistance,weatherproof, long-lasting using in the temperature range -60 °C ~200 °C outdoor.It is quicker than single component silicone in whole curing time,so it’s better suitable in pouring bigger electronic moulds and products.Corrosion resistance,ozone resistance,ultraviolet radiation resistance, waterproof and dampproof. It has a good effect in dampproof ,dustproof and corrosionproof for the filled electronics.
2.Typical application: Pouring sealing to protect general electrical moulds,LED backlight, transformer and relay and so on.
1. Measurement: Be exact Metage for A and B components.2. whipping: Adding B to vessel with A then mixing equably.3. Pouring: Filling to products ASAP.4.Curing in room temperature. It can run into next process after primary curing.
.Mixing A&B compenent equably before using.
.he mixed material should be in sealed storage and be used up during the safety operation,or it’ll slowly cure to wastage
It has the connection for curing time to temperature of the material, the lower for the temperature,the longer for its curing time.
.It’s non-dangerous goods.But pls don’t have it touch mouth or eyes .If it happens,pls flushing yourself quickiy with enough rinsing.
.Do not mix up Priming with silicone material.First daub priming,then pour seal after dryness.
Mixture ratio (A:B)
Operation allowed time (min)
Cured time (h)
Bonding strength (kgf/cm2)
Volume resistivity (Ω.cm)
Breakdown voltage (kv/mm)
Dielectric constant (60Hz)
Dielectric dissipation factor (60Hz)
• :Packing Specification
21.2 kg/set (Including A 20kg and B 1.2kg)
• :Storage and transportation
1.Keep in dry place, the shelf time is one year(Below 25°C)
• It’s the non-dangerous goods, and it should be transported as the common chemicals.
• The components A and B must be stored seally and separately, be careful of leaking when in transporation.