by your order or according to the feature of product
flange rubber expansion joint
BSP designed standard
cost-effective expansion joints
Our factory's introduction:
The Liangda Rubber Expansion Joints are designed for piping systems to absorb pipe movements, relieve stress, reduce system noise/vibration, compensate for misalignment/offset and to protect rotating mechanical equipment against start-up surge forces.
Properties of Rubber expansion joints: Because of rubber has superior capability in resistance of acid, alkali, oil, and electrolytic, Rubber Expansion Joint has become one of the alternatives of stainless steel and been successfully installed in tough demanding applications such as: Chemical/Petrochemical, Marine, Power Generation, Pulp/Paper, Steel Mills and Water/Wastewater Treatment.
The specification of rubber expansion joints: The Single Sphere Rubber Joint is a single sphere design with less length, the supply range is from 25mm to 3000mm, and design pressure can be 1.0MPa/1.6MPa/2.5MPa, which is always used where low cost or space limitation control.
Rubber Expansion Joints Features and Benefits:
1, Versatile hand-built construction. Made in China 2, Absorbs directional movement 3, Absorbs vibration, noise and shock 4, Compensates for misalignment 5, Wide flowing arch design 6, Virtually eliminates sediment buildup 7, Economical fully molded construction 8, High vacuum rating (up to 30" Hg) can be supplied for certain sizes 9, Special grooved flange ring design, prevent rubber end pulling out 10, Solid galvanized steel floating flanges speed the installation time 11, High tensile aircraft cable is embedded in the raised face rubber ends to prevent pull out and avoids the sharp cutting edge of solid steel rings 12, No gaskets required; integrally rubber flanged design, no gaskets required, DIN PN10/16 drilling standard, other flange drilling available, including ANSI 150lb/300 lb, BS, and JIS
Note: 1. Rubber expansion joints supply range can be up to DN3000, detailed data can be offered upon request. 2. Control units must be used when piping is not properly anchored. 3. The rated pressure 2.5MPa rubber expansion joints will only be sold with control units. 4. Rubber expansion joint pressure rating is based on 30°C operating temperature. The pressure rating is reduced at higher temperatures. 5. Rubber expansion joint weights in the above table are joints with DIN PN16 drilling retaining ring flanges. 6. Movements shown in the above table are non-concurrent. 7. Rated pressure in the above table is the maximum "working pressure". Rubber expansion joint test pressure is 1.5 times "working pressure", Burst pressure is 4 times " work pressure". 8. Normally, the rubber expansion joint flange drilling is based on DIN PN16, ANSI 150/250/300 lbs, BS PN10, JIS 10K are also available upon request.
Rubber Expansion Joints Composition and Material:
Nylon cord fabric
Hard steel wire
Mild steel/Cast Iron/Stainless Steel
Rubber Expansion Joints Function and performance:
Working Pressure MPa
Explosion Pressure MPa
-20--115 centigrade(for special requirements could reach to-30--250 centigrade )
Gongyi City Liangda Tubes Co., Ltd. was established in 1985. Our predecessor is Gongyi Changfen Village Mechanical Factory. In 2007, our company was transformed into a limited liability company (Gongyi City Liangda Tubes Co., Ltd.; GYLDT for short). Since foundation, our company is specialized in the production of rubber expansion joints (flexible rubber joints) , rubber check valves (duckbill valves), steel expansion joints, flexible butterfly valves and flanges.