1. One component thread locker sealant glue
2. Use in -50--150 degree
3. 69.5MPa sealing pressure
4. MSDS and ISO9001
Senior Member of Shanghai International Chamber of Commerce
Uncured Testing Term Testing Standard Typical Value Range Appearance(uncured) Purple Liquid Chemical Type Methacrylate Ester Viscosity(mPa.s) GB/T2794-1995v Brookfield RVF3#rotor 2.5rpm 17000 9000-20000 Density( g/cm3 ) GB/T 13354-1992 1.05 1.00-1.10 Flash Point( °C ) SH/T0733-2004 >93 Maximum thread diameter M36 Fixed Time(h) <1 Fully Cured Fully cured at RTV(h) 24 Maximum sealing pressure(MPa) 69.5 Strength for remove Medium Sealing pressure of work time Medium Operation Temperature -50-150
% of Initial Strength Environment °C 100 hr 500 hr 1000 hr Motor Oil 125 100 100 100 Unleaded Gasoline 22 100 100 95 Ethanol 22 100 100 90 Acetone 22 100 95 95 Water/Glycol 87 100 100 100
Features 1. One component, requires no mixing 2. Low intensity, high thixotropic property. 3. Anaerobic sealant, not used in pure oxygen and/or oxygen rich systems 4. Cured in the absence of air between two surfaces.
Professions involved 1.Sealing and locking of high pressure and hydraulic power system(With tapered thread joint) 2.Sealing and locking of taper thread within M36(NPT). 3.No pollution and blocking to hydraulic and pneumatic devices. 4.Being ued on slightly soiled surface.
1.For better results, clean all surfaces(external and internal) with a cleaning solvent and allow
2.Apply a 360 bead of product to the leading threads of the male fitting, leaving the first thread free.
Force the material into the threads to thoroughly fills the voids. For bigger threads and voids,
adjust product amount accordingly and apply a 360 bead of product on the female threads also.
3.Properly tightened fitting will seal instantly to moderate pressures. For maximum pressure
resistance and solvent resistance allow the product to cure a minimum of 24 hours.
4.Shake up after long-term deposit.
Contact: Belinda Liu: Hey, I'm very glad to have the chance to be friend with you!!