Clockwise when viewed from the driving end. A cast mark is made on the delivery casing .
RANGE: Pipe Size: 25*25 mm to 100 *100 mm Capacity: Up to 37 lit/sec (133m3/hr) Head: Upto 76 meter Power: 0.75 Kw to 15.0 Kw (1.0 to 20 HP) APPLICATION: *Ideal for irrigation. *Extremely useful for industrial application. *Suitable for water supply schemes for apartment buildings, hotels, industrial and commercial complexes. *Very useful for sprinkler irrigation Refrigeration and air conditioning applications. CONSTRUCTIONAL FEATURES: *Compact, lightweight Interchangeability of similar pump part. *Central delivery makes air release cock unnecessary. *All rotating part are dynamically balanced; this results In longer bearing life, low noise and high pumping efficiency. SPECIAL FEATURES: *TEFC construction of motor B & F class insulation. *Non-overloading characteristics. *Flatter efficiency character. *High peak efficiency. *Low NPSHR. *These result in high lifting capacity. MOTOR UNIT: *2 Pole and 4 pole motor suitable for 415V /50Hz (single phase) supply. These Monoblocks have the unique ability to withstand large voltage fluctuations. *300-400V for 3-phase and 180-240V for single phase supply. These Monoblocks have the unique ability to withstand lower voltage fluctuations better than that of most of the other makes. CASING: Latest casting techniques give very smooth hydraulic passages. This result in high efficiency reliability and consistency of performance. IMPELLER: Dynamically balanced radial/Francis type, enclosed impeller. Shaft: The high tensile steel shaft is accurately machined and ground it is supported by antifriction bearings which take the residual axial thrust and prevent radial run-out. A shaft sleeve protects the shaft from wear in the stuffing box aria. Stuffing box: In single phase Monoblocks, the stuffing box is sealed by a mechanical seal, and in 3-phase Monoblocks, by a gland packing stuffing box depth is provided for guaranteed sealing. Direction of rotation: Clockwise when viewed from the driving end. A cast mark is made on the delivery casing . Bearings: The standard lubricant for bearing is grease (lithium based grease servo jem-3) Flanges: Standard optional Suction and BS-10 Table D DIN 2576, Delivery flange ND-10,BS-4504, 16/11, ASA 150, 300 ANSI 16.5 Protection: Standard models are with IP-4 protection. 3-phase models can also be offered with IP-55 protection against specific requirement. Quality: The inbuilt design features and excellent workmanship norms followed by us ensure the consistent and excellent quality of our pumps. We satisfy all the requirement of IS specifications. (SINGLE PHASE) APPROXIMATE PERFORMANCE AT 210 VOLTS, 50 HZ SUPPLY