Kafuter K-0222 Dow Corning 688 Chemical Anaerobic Pouring Sealant
( Seal for below M12 fasteners)
|Testing Item:||K-0222 Anaerobic Thread Sealant|
|Main ingredient:||epoxy resin methacrylic|
|Viscosity:||thixotropic, in 1000~5000mPas |
|Prevail Torque:||4 N.m|
|Break torque:||8 N.m|
|Working temperature:||-54~+149°C |
|Room Cure time(at 25°c):|
≤20 minutes(Initial cure time)
24 hours (Full cure time)
One-part, thixotropy,moderate viscosity,and low strength anaerobic metal thread locker sealant.
Seal and lock below M12 metal thread fasteners to prevent its loosening, leakage and corrosion. Especially locking the screws which easy to disassembly, like adjust and lock the fixing screws, small diameter or long thread fasteners.
a) Remove the oil and grease from the surfaces to keep it dry and clean
b) the threads should be coated enough glue until filling the whole gap. the best coating ways is coating the threads with a thin film with 0.05mm
c) Tighten the thread and wipe off the excess adhesive
d) After 15 minutes curing, you will have the initial bonding strength and after 24 hours, you can get the full bonding strength
(1)Keep away from the children.
(2)This product may produce some irritating odor during working time. if contact with your eyes or skin, pls flush with water, if serious, you should go to hospital.
(3)The storage life is 12 months, it should be store in dry and shade place under the temperature of 15°c to 28°c