US $ 3.0-8.0 / Piece10 Carton/Cartons
|Place of Origin:||
Guangdong China (Mainland)
|Main Raw Material:||
repair air hole/sand holes/shrinkage/cracking
|Delivery Detail:||About a month after receiving the T/T|
joint compound sealant
1.two-part, general purpose, gel-formulation
2.repair air hole/cracks/sand hole in castings
Kafuter K-9110 Epoxy Joint Compound Sealant
K-9110 is two-part, gel-formulation, and general purpose epoxy glue adhesive.
Such as, impairing the sand holes, air holes, filling the cracking, and mending the mistakes in processing.
Best performance in repairing and filling of the sand holes, air holes, shrinkages, adn cracking in the machine castings
Remove the oil and grease from the surface, also should be abrasived and polished.
Two-part, please mix and forge the two parts by equal ratio. It will become gel-formulation at the low temperature, it can change into soft gel heating by the heating producer.
Notice: Do not heat with the open-fire
After 24 h room cure, it can put into use.
First, coating the surfaces with some glue, and then push and repeat coating the surface until it exhaust the air and fully fill the gap.
When the room temperature is lower than 10°C, and after 1-2 h room cure, use heat producer heating for 3-4 hour bewteen 80°C, the heating producer between the parts should keep a distance of 300-400mm. and the small-area fittings can be put into the oven for heating below 80°C.
(Heat Producer: infra-red lamp, electric stove, and other heating sources, not use the open-fire)
After cured some time, it can be processed by ordinary ways, and wait for 18 hour, it can use the machine for processing.