|Place of Origin:||Guangdong China (Mainland)||Classification:||Double Components Adhesives||Main Raw Material:||Silicone|
|Usage:||Construction,Transportation||Brand Name:||kafuter||Model Number:||5312T|
Part A:transparent elastomer Par B:transparent liquid
|Mix Ratio(by weight):||Part A:Part B=10:1|
|Packaging Detail:||22kg/pairs, PartA:Part B=10:1|
|Delivery Detail:||About a month after receiving the T/T|
2.potting in deep-section 6mm-2cm
Kafuter LED K-5312T Silicone Pouring Sealant
1) K-5312T is two-component, room cure silicone encapsulant.
2) It become transparent elastomer after cured, water and moisture proof, good transparency, and yellow resistance.
3) Apply in deep-section potting and fixing in 6mm~2cm.
4) Good adhesion to metals and mostly plastics(epoxy resin, polycarbonate, nitrile rubber, epdm)
Encapsulating and potting inLED module, general electronic components, PCB board, and beads in LED strip lights, led rigid bar light, etc.
A: Clear transparent liquid
B: Clear transparent liquid
Density (25°C, g/cm3)
Mix Ratio(by weight)
Controllable Time (25°C,min)
Mixed Viscosity(25°C, mpa.s)
Initial Curing Time(25°C,h)
Full Curing Time (25°C,h)
(Shore A) Hardness(24h)
Fully mix component A before using, accurately weighing A part, and then put the Part B to mix with Par A by mix ratio. It can adjust by your own needs according to the specification.
Put Part B in the bottle with Part A, evenly mix them immediately. And should tighten-sealed the Part B after using.
Put the mixed glue evenly into the product which need encapsulate immediately.
The encapsulated components can be room cured, and it can put into next process after 10 to 24 hours full cure.