CONSTANT CURRENT REGION
RIPPLE & NOISE (max.) Note.2
VOLTAGE TOLERANCE Note.3
SETUP, RISE TIME
1500ms, 80ms /115VAC at full load 1500ms,80ms/230VAC
HOLD UP TIME (Typ.)
16ms at full load 230VAC/115VAC
PF>0.97/115VAC, PF>0.95/230VAC ,PF>0.92/277VAC at full load
90~ 305VAC 127 ~431VDC
47 ~ 63Hz
AC CURRENT (Typ.)
0.4A/115VAC 0.25A/230VAC 0.2A/277VAC
INRUSH CURRENT (Typ.)
COLD START 45A(twitdth=200μs,measured at50%ipeak)at 230VAC
<0.75mA / 240VAC
95 ~ 108%
Protection type:Constant current limiting, recovers automatically
after fault condition is removed
Protection type : Shut down and latch off o/p voltage, re-power on to recover
100°C ±5°C(TSW1)Detect onU2
Protection type : Shut down o/p voltage, recovers automatically after
temperature goes down
Hiccup mode,recovers automatically after fault condition is removed
-35~+70°C (Refer to derating curve)
20~95% RH non-condensing
STORAGE TEMP., HUMIDITY
10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes
,EN62384,J61347-1,J61347-2-13approved,IP67approved:Design refer to
Compliance to EN55015, EN61000-3-2,-3,Class C(>55%load) EN61000-3-3
Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547 light industry
Level (surge 2KV)criteria A
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH
420.1K hrs min. MIL-HDBK-217F (25 )
1 All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of
2.. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated
with a 0.1uf & 47 uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The
final equipment mustbe re-confirmed that it still meets EMC directives.
5.Constant current operation region is within 55%-100% rated output voltage.This is the suitable for more details.
6.Length of set up time is measured at cold first start.Turning ON/OFF the power supply may lead to increase
of the set up time.
7.Derating may be needed under low input voltage.Please check the static characteristics for more details.
8.Direct connecting to LEDs is suggested, but is not suitable for using additional drivers.
9..Suitable for indoor use.