CONSTANT CURRENT REGION Note.6
100 ~ 200V
RIPPLE & NOISE Note.7
CURRENT ADJ. RANGE
Can be adjusted by internal potentiometer A type only
210 ~ 350mA
SETUP. RISE TIME
1500ms, 80ms / 115VAC at full load 1000ms, 80ms / 230VAC at full load
HOLD UP TIME (Typ.)
16ms at full load 230VAC / 115VAC
VOLTAG ERANGE Note.2
90 ~ 305VAC 127 ~ 431VDC
POWER FACTOR (Typ.)
PF>0.98/115VAC, PF>0.96/230VAC, PF>0.94/277VAC at full load (Please refer to "Power Factor Characteristic" curve)
TOTAL HARMONIC DISTORTION
Total harmonic distortion will be lower than 20% when output loading is 75% or higher
AC CURRENT (Typ.)
0.69A / 115VAC 0.35A / 230VAC 0.29A / 277VAC
INRUSH CURRENT (Typ.)
COLD START 60A(twidth=275£g s measured at 50% Ipeak) at 230VAC
<0.75mA / 277VAC
Hiccup mode, recovers automatically after fault condition is removed
230 ~ 250V
Protection type : Shut down o/p voltage with auto-recovery or re-power on to recovery
Protection type : Shut down o/p voltage, re-power on to recover
-40 ~ +70°C(Refer to "Derating Curve")
10 ~ 95% RH non-condensing
STORAGE TEMP., HUMIDITY
-40 ~ +80°C, 10 ~ 95% RH
±0.03%/°CJ(0 ~ 50°C)
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
SAFETY STANDARDS Note. 3
UL8750, CSA C22.2 No. 250.0-08, EN61347-1, EN61347-2-13 independent, IP65 or IP67 approved
I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25°C/ 70% RH
Compliance to EN55015, EN61000-3-2 Class C (≥60% load) ; EN61000-3-3
Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, heavy industry level (surge L,N-FG: 4KV), criteria A
338K hrs min. MIL-HDBK-217F (25°C)
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.
2. Derating may be needed under low input voltages. Please check the static characteristics for more details.
3. Safety and EMC design refer to EN60598-1, CNS15233, GB7000.1.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by thecomplete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
5. Refer to warranty statement.
6. Constant current operation region is within 50% ~100% rated output voltage. This is the suitable operation region for LED related applications, but please
reconfirm special electrical requirements for some specific system design.
7. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 2.2uf parallel capacitor.