SAFETY MODEL NO.
DC VOLTAGE Note.2
0 ~ 6.67A
RIPPLE & NOISE (max.) Note.3
VOLTAGE TOLERANCE Note.4
LINE REGULATION Note.5
LOAD REGULATION Note.6
SETUP, RISE TIME Note.8
1000ms, 20ms / 230VAC 1000ms, 20ms / 115VAC at full load
HOLD UP TIME (Typ.)
20ms / 230VAC 20ms / 115VAC at full load
VOLTAGE RANGE Note.9
90 ~ 264VAC 127 ~ 370VDC
47 ~ 63Hz
POWER FACTOR (Typ.)
PF>0.91 / 230VAC PF>0.95 / 115VAC at full load
2A / 115VAC 1A / 230VAC
INRUSH CURRENT (max.)
70A / 230VAC
1mA / 240VAC
110 ~ 150%rated output power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
105 ~ 135%rated output voltage
Protection type : Shut down o/p voltage, re-power on to recover
RTH30 > 100°C
Protection type : Shut down o/p voltage, re-power on to recov er
-30 ~ +50°C(Refer to "Derating Curve")
20%~90% RH non-condensing
STORAGE TEMP., HUMIDITY
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY&EMC (Note. 7)
UL60950-1, TUV EN60950-1, BSMI CNS14336, CCC GB4943, J60950-1(except for 48V) approved
I/P-O/P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC
I/P-O/P:100M Ohms /500VDC/25°C/70% RH
Compliance to EN55022 class B, EN61000-3-2,3, FCC PART 15 / CISPR22 class B, CNS13438 class B, GB9254 class B, GB17625.1
Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A
348.7K hrs min. MIL-HDBK-217F(25°C)
Standard type P1M: 2.5ψ* 5.5ψ* 11mm, tuning fork type, center positive for stock ; Other type available by customer requested
See page2; Other type available by customer requested
1.All parameters are specified at 230VAC input, rated load, 25°C 70% RH ambient.
2.DC voltage: The output voltage set at point measure by plug terminal & 50% load.
3.Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor.
4.Tolerance: includes set up tolerance, line regulation, load regulation.
5.Line regulation is measured from low line to high line at rated load.
6. Load regulation is measured from 10% to 100% rated load.
7.The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meetsEMC directives.
8. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
9. Derating may be needed under low input voltages. Please check the derating curve for more details.