US $1.77 / Piece300 Carton/Cartons
US $1.0 - 2.0 / Piece300 Carton/Cartons
|Place of Origin:||
Guangdong China (Mainland)
|Main Raw Material:||
1.Provide a permanently elastic joint sealant high strength when cured;
2. Excellent weathering properties.
D600 Construction Adhesive is a high strength, professional quality adhesive specifically formulated to eliminate much of the nailing required for construction purposes.
The adhesive provides a high strength, water resistant band to a wide variety of materials, including wood, structural flooring panels, particle board, masonry, aluminum, galvanized iron, steel, concrete and fibrous cement sheeting.
No suitable for ethylene foam material.
1. High strength and Professional quality adhesive.
2. Excellent resistance to weather, suitable to use indoor and outdoor.
3. Excellent adhesion, little abnormal odors, can painting after it dry.
1.Ensure the surfaces are dry and clear.
2. Grease and opening.
3.Applly using a cartridge gun Assemble Joint within 10 minutes using nails, screws or clamping sufficient to give contact .
4.Over the whole area.
5.Allow adhesive to set(at least 24 hours)before removing clamps or temporary(On flat surfaces, apply full length beads at
least every 40cm).
6.Lightweight materials and low stress joints can be bonded by “contact bonding”.
7.Apply adhesive and assemble joint as above.
8.Then pull surfaces apart, wait a few minutes to let it dry, then press surfaces firmly together and tap firmly along the joints.
1.Remove uncured adhesive with xylene or scraper.
2.Cured adhesive is best removed by scraping or sanding.
1.Store inside where possible, out of direct sunlight.
2.Storage areas should be well ventilated and kept to a maximum of 27°C.
1.Avoid contact with eyes and skin.
2.If poisoning occurs, contact a doctor.
3.If swallowed Do not induce vomiting.
4.Keep out of reach of children.
6.Use in well ventilated areas away from heat, sparks and naked flames.