US $1 - 149 / Piece1 Pallet/Pallets
US $28 - 35 / Set50 Set/Sets
US $1 - 99 / Piece1 Pallet/Pallets
US $149.0 - 149.0 / Pair1 Pair/Pairs
30 amp pulse width modulator completely assembled and ready to install for HHO hydrogen generator system includes fan, enclosure
PWM Pulse Width Modulator KIT for HHO Hydrogen Generator Cell 30 amp with many extras as seen in Picture or Buy PWM Alone
This is a small completely assembled device ready to install with an on-board trim pot to control the pulse width modulator output. Keep in mind that you should determine how hot the unit gets. If it gets to hot it will fail, in order to be able to carry high amperage for extended periods of time you will need to provide additional cooling. The Fan we provide is perfect for keeping this PWM Cool. The unit will carry up to 30 amps.
Power Supply: 12 or 24 Volts DC (Car Battery OK)
Load Voltage: 12/24VDC 30 AMPS
Output Frequency: 400 Hz
Output Power is Adjustable from 0% to 100%, or anything in between. ( Perfect to control just the right amount of Hydrogen Production )
PCB Dimensions: 3.85 x 1.59
CONNECTING AND OTHER SPECIFICATIONS
POINT + 12 V is connected to the positive pole of the power supply 12VDC (+ of car battery)
POINT + M is connected to the positive pole of the Hydrogen Cell.
POINT - M is connected to the negative pole of the Hydrogen Cell.
POINT G is to be connected to the negative pole of the power supply. (- of car battery)
VR 10K is used to adjust the speed of the Hydrogen Cell.
J is used to select the power supply 12v or 24VDC for the Hydrogen Cell .
I have used these devices before and this model seems to work the best for hydrogen production.
The PWM Circuit Board is not a kit. It is Brand New, Fully Assembled and tested to be in working order before it is shipped.
This PWM will work without the use of the Fan, Enclosure, relay, switch, meter, shunt. These extra items are provided "as is" only as a free bonus. In order to install these items, you must have knowledge of electronics and wiring We are unable to provide lessons on simple wiring of electronics. If you don't know what you are doing then this offer is not for you. If you choose to install this PWM inside of the Enclosure, you must also install the Fan to prevent overheating. This will require the connection of two wires for the Fan, a hole to be drilled for the removable control knob, and some cutting of the plastic case and/or aluminum lid to allow for the Fans air flow.
Because of the nature of the product it is being sold AS-IS, no refunds or returns.
Your purchase means YOU agree to these terms.
Labella's Auto Repair
Kenner, Louisiana 70062
HHO Sales, Service, Testing
504 469 9986