RTV gasket maker
1.It can substitute any gasket instantly,the specific gravity is 1.2-1.6 g/m3
2.Room temperature solidification,after curing,it resists cracking,shrinking and migration caused by thermal cycling,surface de-viscidity is 20-30 minutes,extention strength is 2.4mpa
3.Good resistance of water,oil,anti-freeze and transmission fluid.
1.Clean surface thoroughly and remove the old gasket then prepare the flange surface.Dry and remove all oil and grease.
2.Open the cap, puncture the inner seal of the tube,screw on the nozzle and cut the nozzle to the designed size.
3.Smear certain amount of sealant around the bolt,make sure the layer is thick enough.
4.Wait for about 10 minute to ensure the solidification effect,then reassemble the parts.
5.Touch it unless it dry for 1 hour and 24 hours to fully cure and bond