Working Based on existing GSM/GPRS network and GPS satellites.
10 meters, 2D RMS
-GPS&GSM Quad-band Real-time Tracking & location and history track
-External Microphone realize remote monitoring
-External SOS button and alarm and speakers
-External Relay realize remote engine power & oil off -Alarm function: Speeding, Vibration, Geo-fence and illegal shift Alarm by
-Built-in battery (support overtime standby & alarm when Electricity
Cutting or lower power)
-ACC mode -Firmware Auto recovery function
-OBDII interface simply installation(optional)
-IOS, Android APP software in set, also support WeChat tracking on line
Sample can be ready in 1-2days,small order can be ready in 2-5 days,big order will depend on the quantity
DHL,UPS,Fedex,EMS,or by sea.
We accept T/T,Western union,Paypal
Power off before SIM card operations;
Please make sure that the SIM card has enough credit;
Special GPRS data SIM Card suggested (GSM network only);
Any metal heat shield layer or heating layer will reduce the signal of GPS, it may cause GPS function failure, please adjust the installation place;
Terminal wiring Instructions
Yellow AAC detection wire,the ACC wire shall connected with the ACC switch, the terminal will decide vehicle status by ACC status, engine on or engine off, also determines the terminal data upload time interval, engine on status: 15seconds, engine off status: 5 minutes;
Engine control relay wiring
Oil pump relay connections: ignition coil with small white wire (85) and small yellow wire (86), small white wire (85) connects with the vehicle power source negative end, small yellow wire (86) connect with the terminal relay control wire;
The controlled vehicle oil pump, cut the oil pump positive wire, the oil pump positive end shall connect with the thick green wire (87a) which is the normally closed end, the another end connect with the relay public end the thick green wire (30);
SOS wire (2 pin)
Connect with the external SOS switch button, used in emergency case for help;
Loudspeaker wire (2 pin)
Connect with the external vehicle speaker, with a microphone, it can make 2 ways phone calls, or send voice alarms when theft behavior was detected;
MIC wire (2 pin)
Connect with external microphone, used in voice monitoring case or phone calls;
After finished all wires connection, please connect with the power supply;
Hidden installation, please choose original main power wire, a fuse block (2A protective tube) on the red wire end will protect the terminal from short circuit;
Start-up: insert the SIM card, turn on back-up power supply, the terminal will start up;
Shut-down: disconnect power plug, take out the SIM card, the terminal will shut down;
Terminal parameters settings
All beginning letters in each parameters’ commands shall use upper-case letters, all punctuations shall be English punctuation, only part of commands will reply.
By sending enquiry commands to the terminal, corresponding contents will be replied.
Commands shall be sent by the bound cellphone number.
Cellphone SIM Card Number Binding
After the terminal start up normally, please bind your cellphone number first, alarms will send to this bound number.
Initial password is 000000, new password is 987654
Get Terminal Position by SMS
Send SMS: DW to terminal, it will reply the terminal current geography location
e.g.: south east 30 meters, ABC company, Meilong Rd, Shenzhen, Guangdong Province
Google Address Link
Send SMS: GOOGLE to terminal, it will reply the terminal current geography location link http://maps.google.com/maps/?f=q&hl=en&&q=31.237395,121.390373333333;S=0;D=2012-5-23 12:00:00;D=0
Please note: the default time is Greenwich time, actual time needs to add your time zone number
e.g.: enquiry time is 12:00:00, Chinese time is 20:00:00 (+ 8 hours)
When the vehicle was stolen, the administrator can send Cut-off Engine command via the live tracking monitoring system, Under the conditions of safe driving, the command will trigger the relay to cut off power of oil pump to stop the engine, and it can’t be re-start the engine without restore engine command.
To secure the safety of vehicle, the terminal shall in valid GPS signal status, also speed under 20km/h or still status to cut off engine.
After the theft alarm dismissed, send restore engine command via live tracking monitoring system will trigger relay to restore the power of oil pump, the vehicle will able to start up.
Cut off Oil pump power
Send SMS: DYpassword to terminal, and reply: Config ok
Restore Oil pump power
Send SMS: TYpassword to terminal, and reply: Config ok
Intial password is 000000
Alarm Method Settings
Send SMS to set the alarm method:
KC0 : Close all arlms;
KC1 : SMS alarm;
KC2 : Phone call alarm;
KC3 : SMS+Phone call alarm;
Default Alarm status:
Park still status (ACC): Vibration Alarm On;
Driving Status (ACC): Vibration Alarm Off;
Send SMS: SF to turn on vibration alarm;
Send SMS: CF to turn off vibration alarm;
Movement Alarm on when the vehicle is at vibration alarm on status.
Turn Off SMS Command: *MVALMOFF#000000#
Turn On SMS Command: * MVALMON#000000#
Condition Set SMS Command: *MVALM#000000#Speed#Vibration Times#
3: Speed>=3km/h & 10 time vibration detected, then movement alarm triggered.
Any emergency case happens, press the SOS button for 3 seconds, trigger the SOS emergency help alarm, the terminal will call the bound cellphone number repeatedly, in nobody answers case, it will ring max 3 times, at meantime, the terminal will upload SOS alarm information to live tracking monitoring system.
Main Power Cut-Off Alarm
After the terminal main power been cut, it will automatically trigger power cut off alarm, it will send a main power cut off alarm SMS to bound cellphone, and meanwhile upload the alarm information to live tracking monitoring system.
SMS e.g.: Alarm main power failure, Please pay attention!
Send SMS: JT to the terminal
The terminal will call back and the administrator will able to monitor the voices.
Bound cellphone calls the terminal, after it gets through, the administrator can talk with the driver via the loudspeaker and microphone connected with the terminal.
Live Tracking Monitoring Platform
Demo Account: Demo
Cluster User Account
Account: Last 10 digits of IMEI
If you already have a login account and password information, you can login our platform directly, or please contact your distributor and ask them to open you an account and provide you the password.
Input the address link in your computer browser, input the account and password, then login to your service platform.
About the use method of platform, please ask your distributor for Service Platform User Manual.
YuLongDa (Hong Kong) Technology Co., Ltd. has been developing wireless products for years.
8 years ago, we developed the first Made-in-China 3G USB module, leading in the market. 5 years ago, we were devoted to GPS industry. Now we have products including GPS trackers and LBS trackers for vehicle, motor, personal, pet, etc.
Notice: We have some changes in HR, below list sales people have left our company: Anson Chen, Lisa xie, Daniel Cao. They won't represent our company more for any ... View detail