3.Labour saving conveyor
4.High shelling ratio
Top quality corn shellers
1)Top quality corn shellers 2) Used to shell the corn seed and mill the corn at the same time 3) Processing material: corn/maize ,grains 4) High shelling ratio
2. Detailed Description
1) The top quality corn sheller is mainly used for shelling the corn kernels from the corn ears after corn harvest.
2) The corn sheller consists of a rack, chassis, roll axis and a network of protection. 3) Inlet is located in front of the machine. Put the dried corn into the feed inlet, the axis of roller stripping, threshing, separation, Corn cleanliness has rare broken rate and Less Corn kernels in the doping impurities, increasing the amount of harvested crops. 4) The corn sheller can be favorable to the rush in the harvest season , saving labor costs and improving harvest efficiency.
5) The main working parts of the corn sheller is installed on the machine rotor, through the rotor and the drum hit and threshing. It is more widely used types of threshing equipment.
3. Technical Parameters
4. Main Working principle
1) This corn sheller can be composed of a single-phase four motor power input spindle assembly through a gear transmission, driving the tore skin Room; 2) The relative rotation of two pairs of steel to tear the skin chamber tear roller can adjust the rocker arm bearing adjustment screw by a spring pressure; 3) The two pairs of tear roller close contact, cluster into the tearing room, steel and tear on the roller tearing claw nail shell bract; 4) The relative rotation of two pairs of roller bract rolling the housing, cover and the cover above to get the rubber adjustment board in the rotation to suppress ear, rely on two rollers rotating force and the pressure of the spring opened bract, so with the cluster separation, to tear the skin.
5. Application and General Adjustment
Tear the level of the net rate by adjusting the nut at the bottom of the rocker arm bearing, roller tightly pressed together by a spring pressure, tear the net rate is low, tighten the adjusting nut, increase the spring pressure or adjust the box of rubber adjustment board, there are four adjusting nut on board available for adjustment. NOTE: During the tearing skin, you should try to avoid the vertical feeding, should be timely clear up the bract and cluster from inside and outside of the machie, otherwise, easily cause bract winding the shaft and blocking the outlet.
Any more question or inquiry about our products, please feel freely contact victor zhang