1.If the substrate surface has oil, dirt and other impurities it will affect the bonding effect.Therefore, the substrate
must be clean before the glue on the surface.
2.The ambient temperature of using this product should be above 10 °C.The product before curing should be maintained
above 10 °C after the adhesive.Otherwise the latex film is not good due to the viscosity decrease,thus affect the quality
3.Select appropriate viscosity of the latex based on equipment situations and different substrate when using this
product.Do not blindly pursue high viscosity latex.
4.Do not add water to use when using this product. Adding water in the latex will reduce the non-volatile matter
content,extend the curing time,and reduce the storage stability. That lead to decreased latex adhesive strength. Thus
affect the quality of products.
5.Be kept sealed after using this product to prevent latex surface crust from waste.
1.The product is water soluble polymer emulsion. It should be stored in airtight containers. Avoid direct loading in iron,
aluminum, copper and other metal containers. Attention to frost and high temperature.
2.Normal storage temperature is 5-37 degrees.If the latex slightly cold, it should be placed within 30-40 degrees of
greenhouse for full remission ,and then stir. That does not affect the use. If severe cold latex for a long time to be not
relieved,and found that agglomeration, layering or emulsion breaking. Does not continue use.
1.The product is water soluble polymer emulsion. It is non-dangerous goods and portable transport.
2.Prevent crashing and inverted when loading and unloading to prevent fragmentation and loss.
3.Keep warm and avoid cold products in winter transport.