HepaClean 2500 / 4000
    - Dust Collection Equipment
    - Powerful suction pressure
    - Imported from Finland, Europe

Scope of Work of Oil Duct Cleaning Service

1                    Use plastic cloth to cover furniture, equipment and floor.

2      Create access openings                        

3        Dismantle air grille for cleaning and disinfection.                    

4          Use inspection Camera to inspect and record the inner part condition of air duct before duct cleaning.            

5          Use sprayer to spray the de-grease solution of c/w high pressure jet hot water into the inner part of air duct.

6          Use inspection Camera to inspect and record the inner part condition of air duct after duct cleaning.            

7      Reinstall the cleaned and disinfected air grille.                       

8                    Install stainless steel access doors to all new created access opening.

9      Clean up the serviced location to ensure no impact of business cycle.

10    Collect and transport the waste after duct cleanings.

Cleaning report with inspection photos (before and after cleaning) will be submitted to the client.

Scope of Work of Electrostatic Precipitator Cleaning Service

1      Inspect and Measure the Working Voltages of the Electronic Cells;

2         Record the Collector Cells, Ionizers and Mesh Filters and take Pictures of the Electronic Cells and Spares before our Professional Cleaning;

3         Spray with Jet on all the Spare Parts (Collector Cells, Ionizers and Mesh Filters) with water in the assigned place. Use the Degreaser (approximately 2 Litres) and dilute with hot water to cover up one Collector Cell;

4     Soak the Collector Cell for 15-20 minutes;

5     Take out the Collector Cell and spray with plenty of water;

6          Soak the Collector Cell with Fin and Coil Cleaner (acidic) in the same way as steps 8 to 10 but with 0.5 Litre of F.C. Cleaner only;

7     Clean the door and interior of each AC/ESP;

8         Record the Collector Cells, Ionizers and Mesh Filters and take Pictures of the Electronic Cells and Spares at this stage;

9     Put back all the Electronic Cells and Spares in its original position;

10   Check and Measure the Working Voltages of the Electronic Cells again.

Cleaning report with inspection photos (before and after cleaning) will be submitted to the client.