CS-70 OPERATIONAL MANUAL

BUTTON 1. A. Arm / Disarm
B. Lock / Unlock
C. 2"( at Arm) Finder
D. 2" ( at Disarm) Trunk (Auxout1)
BUTTON 2. A. 2" Panic
B. 2"( at Ignition ) Anti-Hi-Jack
C. Release panic and Anti-Hi-Jack
BUTTON 1 + 2 A. Silent Arm/Disarm
B. 2" ( at Arm ) Shock bypass
C. 2" ( at Ignition ) Valet

CODE LEARNING:
Turn ignition on, press and hold over-ride switch 5 sec. till siren 5 chirp, parking light and LED steady on, it means
system now in code learning mode.
Press any button of 1st transmitter for learning, parking light flash 2 times means learning successful and waiting
for 2nd new transmitter to learn.
Press any button of 2nd new transmitter for learning, parking light flash 3 times means learning successful and
waiting for 3rd new transmitter to learn.
Same procedure for code learning maximum up to 4 transmitters.
The system will back to normal mode If without any transmitter signal send out for learning within 10 seconds.
Every time learning new transmitter, original code (old transmitter) will be erased. Hence old transmitter must also
learn again when new transmitter need to learning.

OVERRIDE SWITCH:
1. When ignition on, press Override Switch 5 sec. for code learning mode.
2. When ignition on, press Override Switch 5 times for valet mode.
3. When alarm, Turn on Ignition, press Override Switch 1 times for emergency disarm. 

FUNCTION INTRODUCTION
1	Arm / Disarm	13	Door Locking Negative Output
2	Silent arm / disarm	14	Double Unlock Pulse (program)
3	Panic	15	Parking Lights Relay Build-in
4	Anti-Hi-Jack	16	Door Lock Pulse Time (program)
5	Remote lock / unlock ( Ignition on )	17	Remote Shock Sensor By Pass
6	Passive Arm Mode ( program )	18	2 Stage Disarms
7	Security re-arm	19	Arm Condition Memory
8	2 Stage Shock Sensor	20	Valet mode
9	5 Second Warning Chirps ( Normal Car/Dome Light Delay Car ) ( program )	21	Auxiliary Ground Output (Aux1)
10	Auto Lock with Ignition	22	Aux2 / Aux3
11	Open Zone Alert by Pass	23	Code Anti- scanning
12	Code Learning	24	Prior Intrusion Alert add 4 chirps after disarmed if door or ignition trigger

How to update program option function
Please following step by step
1. Turn ignition on.
2. Press and hold the override switch for 5 seconds till the Siren 5 chirps, Parking
Light and LED steady on, then release override switch. Now entry the
Program mode
3. Use the override switch again with short press to select the number of program
setting and each press confirmed with chirp
4. Now use remote to setting the option by button 1(confirmed 1 chirp) or button
2 (confirmed 2 chirp)
5. Press override switch again for next program, same as last step (No. 4)
6. To exit program mode, waiting 10 sec. and do nothing for automatic exit or just
turn the Ignition off.
7. Please note that any button program of the No. 8 option will back to the default
setting.