ISBM-120 Automatic Injection Stretch Blow Molding Machine
Technical Parameter

General parameter
Applicable material  PET, PC,PP,PA etc.
Nominal capacity:   900bottles/hr  (PET, 16g, 4 cavities for each mold) 
Screw diameter:   Φ40mm
Length/dia. ratio of screw:   20:1
Max. theory injection volume:   120cm3
Max. injection velocity:   98cm3/s
Max. injection pressure:   120MPa
Max. plasticization:   12g/s
Screw rotating speed:   0-170rpm
Barrel heating power:   10.3kW
Hot runner heating power:   4 kW-5kW  (According to the number of cavity)
Injection core closing force:   130kN
Injection core stroke:   250mm
Die lip closing force:   130kN
Die lip stroke:   205mm
Blowing mold closing force:   130kN
Blowing mole stroke:   75mm+75mm
Temp. regulating core stroke:    250mm
Temp. regulating tank stroke:   230mm
Tank heating power:  1-2kW  ( According to the number of cavity )
Product ejection stroke:  170mm
Pressure of oil system:  16MPa  (max)
Oil pump motor power:  18.5kW
Oil pump flowrate:  105L/min +55L/min
Total power : 34kW  (The parameter differing on the number of cavity)
Working power :  55% approx.  (The parameter differing on the type of product)
Overall dimension:   4100mm×1000mm×3000mm  (L×W×H)
Weight:   approx 4.2 tons
  
Outsourcing power
Power source:  3N+PE  50Hz  380V/220V  (Three-phase five-wire) 
Blowing air-pressure:  3-3.5MPa  (PET) ,        1.2-1.5MPa  (PCPP)
Blowing air-flowrate:  500L/min
Pressure for low-pressure air:  0.7-0.9MPa
Flowrate for low-pressure air:  40L/min  (0.7-0.9Mpa under working pressure)
Cooling water pressure:  0.3-0.4MPa
Cooling water flowrate:  50L/min  (PETPP)
Cooling water temperature:  10-15   (PET) ,      15-30   (PP)
Flowrate for cooling tower :  80L/min
Pressure for cooling tower:   0.2-0.4MPa
Cooling tower temp.:   5-32