Injection Adhesives

       JG-602 injection adhesives is a two-component, 100% solids epoxy-based system,so call epoxy adhesive too.It use as a high strength, non-shrink anchor grouting material. Resin and hardener are dispensed and mixed simultaneously through the mixing nozzle.

Uses:

·Threaded rod anchoring
·Rebar dowelling
·Bonding hardened concrete to hardened concrete
·Pick proof sealant around doors, windows and fixtures
·Paste-over for crack injection.

Application:

       Surfaces to receive adhesive must be clean and free of frost. The base material temperature must be 0° F or above at the time of installation.The cartridges should be stored in a warm, uniformly heated area or storage container for a sufficient time to allow epoxy to warm completely. Mixed material in nozzle can harden in 2h at a temperature of 25.

Specifications:

SHELF LIFE: Twelve months from date of manufacture in unopened cartridge.

STORAGE CONDITIONS: For best results store between 32° F - 80° F. Partially used cartridges can be stored for a limited time by leaving nozzle in place.  To re-use, attach new nozzle.

COLOR: Resin-white; Hardener-black or red or gray, amine based. When properly mixed SET adhesive will be a uniform gray or pink color.

CLEAN UP: Uncured material Wipe up with cotton cloths. If desired scrub area with abrasive, water based cleaner and flush with water. If approved, solvents such as ketones (MEK, acetone, etc.), laquer thinner, or adhesive remover can be used. DO NOT USE SOLVENTS TO CLEAN ADHESIVE FROM SKIN. Take appropriate precautions when handling flammable solvents. Solvents may damage surfaces to which they are applied. Cured Material: Chip or grind off surface.

CHEMICAL RESISTANCE: Very good to excellent against distilled water and inorganic acids. Fair to good against organic acids and alkalis, inorganic alkalis, and many organic solvents. Poor against Ketones.

Technical data:

Related products:

Hole Cleaning Brushes: Brushes are used for cleaning drilled holes prior to adhesive anchor installation. Brushes have a twisted wire handle with nylon bristles.

Dispensing Tools:

1.Mixing Nozzles;

2.Plastic Anchoring Screens:

3.Mixing Nozzles and Retaining Nuts: mixing nozzles with integrally molded retaining nut

4.SUGGESTED SPECIFICATIONS: Anchoring Adhesive shall be a two-component acrylic based system supplied in manufacturer's standard side-by-side or coaxial cartridge and dispensed through a static-mixing nozzle supplied by the manufacturer. compressive yield strength after 8 hours cure.

Installation into Concrete:

Drill:Drill hole to specified diameter and depth.

Clean:Remove dust from hole with oil-free compressed air. Clean with nylon brush and blow out remaining dust.

Note: Dust left in hole can reduce the adhesive's holding capacity.

Fill: Fill hole 1/2 - 2/3 full, starting from bottom of hole to prevent air pockets. Withdraw nozzle as hole fills up.

Insert Anchors:Must be clean and oil free. Insert anchor, turning slowly until the anchor contacts the bottom of the hole. Do not disturb during cure time.

Important

The information and data given is based on our own experi­ence, research and testing and is believed to be reliable and accurate. However, as Chemfix Products cannot know the var­ied uses to which its products may be applied, or the methods of application used, no warranty as to the fitness or suitability of its products is given or implied. It is the users responsibility to determine suitability of use. For further information please contact our Technical Department.