5050 led strip, strip led, rgb led strip light

Product Introduction

1 SMD5050 led flexible strip, using constant voltage 12V drive, high-brightness, low current

2 3 / 6 leds can be cut, max available in 5 meters

3 30pcs 5050LED per meter,every three LEDs as a cuttable unit (50mm), PCB board could be bent easily(a big break t traditional installation)

4 its unique LED three-chip structure, make it in the heat sinking, lifetime ,get a good control, two-year warranty.

5  standard length:1M, 3M, 5M (optional or according to the client request)

6 It can reduce the energy consumption,lower emissions,improve the energy saving and emission reduction effect of the city’s lighting

7 Emitting color: Red, Yellow, Blue, Green, White, Warm White

8The diameter of power cord should be based on the actual maximum current,the product

power ,cabling length(recommended no more than 5meters),and the voltage of transmission line.

9 Extremely luminous,with wide viewing angle

10High efficiency and energy-saving compared to conventional fluorescents-equally bright, consumes 70-80% less energy

  11 Match the RGB controller and power supplier system.

Applications:

1.Architectural decorative lighting 
2. Archway, canopy and bridge edge lighting 
3. Amusement park, theater and aircraft cabin mood lighting 
4. Emergency hallway lighting 
5. Auditorium walkway lighting 
6. Stairway accent lighting 
7. Concealed lighting 
8. Backlighting for signage letters 
9. Channel letter lighting 
10. Emergency exit path lighting 
11. Cove lighting

12.Widely applied to hotel,KTV entertainment place for intereior decorative

13  Swimming pool and fountain

14 DIY lights for home use

15 Path and contour marking

16 exhibition stands and panels, display cases, etc.

Performance Parameter

  Installation and dimensions

Installation with 3M double-sided tape to stick, the dimension chart is as follows (unit: mm)

Attention

Product should meet “use environment” requiremetn when they work.

Installation Instruction

1.In the choice of power cord, power cord should be noted that the current carried should be larger than normal working current by the lamp brought.

2.Controller and switching power supply must work in ventilated and dry environment.

3.Make sure the input wire or output wire of control bus without a short circuit before operation. In the case of work such as short circuit, the internal components may be destroyed

Attention

1. Suggest led strip connection with length no more than 5meters. 3/6LED as a loop, the interface can be cut to use, but can not be cut in the middle of a loop 

2.Collocate suitable power supply according to the total power after strip concatenation, and also pls assure the power of led adapter must be larger than the load power, or else the power supply will be burned out.

3. LED strip drove by DC12V, pls do not use output DC5V or DC24V power supply, it will not light or burn out; if by DC24 driver, pls do not use output DC12V or DC36V power supply, same as above.

4. This product is non-waterproof led series strip, suitable for indoor application, not in the rain or put into the water.

5. The soft silica gel is on the LED surface, forbid any chemical solvent smear on the surface which have chemical reaction with silicon, otherwise the leds can not light.

6. Working temperature is -10 C°~ +40 C°.

7. If the lamp body is damaged, it must use the new alternative.

8. It can not connect power when installation or removal.

Packing