Sell F, T Rubber Active Agent

F, T rubber active agent technology developed by the University of Science
and Technology of China, the use of rich mineral resources development
and reinforcing agent, dispersant, wetting agent, a variety of special process
again surfactant composition made of high-tech processing and environmental products.

By the Ministry of Chemical Industry Research and Design Institute of Rubber
Industry, and many manufacturers test and the use of rubber, natural rubber products in the show, synthetic and replaced with plastic moderate znlo/2 all
formula and the remaining indirect zinc oxide and used as active agent can be
fully met or exceeded all of the effects of zinc oxide alone.

F, T rubber activity and the use of zinc oxide is difficult to eliminate the use of decentralized weaknesses, good materials scattered throughout the system, meanwhile activated curing system as a whole to achieve the activity of curing
to increase curing curve flat, relatively safe process, vulcanized rubber products
and greatly improving overall performance.

F, T zinc oxide and rubber active agent with the best ratio: F, T/znlo=50/50 - 60/40
in such cases over the scope and use, and single zinc oxide, apart from the above advantages as well with the most significant following advantages:
1) T10 long, T90 (%)=-4.49 x SaO₂ short, mix materials to improve
the focus of practice time, and improve plastic raw material processing safety
and shorten the curing time and raise the efficiency of production
2) Aging agent performance
3) Raise the NBR oil resistance
4) Has also improved the physical properties of vulcanized rubber
5) Compound significantly lower costs, and increase product efficiency