This is a vertical sterilizer used to the sterilization of food in can and glass jar…. After sterilization, your product will obtain a long shelf life.
This machine use electric as heating medium. Usually operators will heat the product to 121 degree C and hold this temperature under 0.15~0.25Mpa pressure for 10~30 mins. Then stop heating and pumping cooling water into the sterilizer in order to speed up the cooling and increase the working efficiency.
Here below is the specification
DN500 × 600
Internal Diameter (mm)
380V 50Hz 3phase
Main Pressure Part Material
Stainless steel 304
Construction material thickness
Net Weight (kg)
120 (by estimate)
100Liter autoclave / retort autoclave / sterilzier autoclave Main part & accessories introduction
Ball valve A
Water inlet valve, used to feed water into the retort chamber. Also, cooling water will be pumped in through this valve.
Ball Valve B
Compressed air inlet valve, before you start to use this machine, please connect this pipe to your compressed air resource. You will need 8×5.5mm hose to combine this valve together with the compressed air resource.
Ball valve C
Pressure Relief Valve, used to release the extra pressure in the retort chamber. When inner retort pressure is higher than the needed pressure, you can open this valve to release the inner pressure. Please close this valve when inner pressure reduced to the acceptable range.
Used to show the inner pressure. For most of food product, pressure usually to be 0.1Mpa to 0.25Mpa
Used to show the inner retort temperature
Used to monitor inner retort temperature, and send the signal to the recorder.
Used to control the inner pressure automatically. When inner retort pressure is higher than 0.25Mpa, this valve will be open automatically. This is in order to protect your product and the retort.
Glass level meter with stainless steel shell.
We offer you an extra glass tube as spare
Level switch prober
Used to monitor inner retort lowest water level. When water level is lower than this prober, system will alarming to reminder you add water or stop heating.
2pcs, 9kw each
Made of full stainless steel. You can start the heating tubes one by one or use them together. The switches for them can be found on control panel.
Used to monitor the sterilization time. When sterilization time finished, system will alarming. Sterilization time is configurable.
Show current temperature and preset the sterilization temperature.
Here are some pictures of our product in our workshop. All copyright reserved.
Photos are taken from different views in order to show you our product.