220V Portable Powered Electric Wire Stripping Machine Scrap Cable Stripper
This machine is easy to operate and convenient to carry, can process single core copper wire, twin cores copper wire.
1.Comparing the wires’diameters with the feeding holes on the machine, feeding the wires one piece at one time. Before feeding the wires, please cut off the head of the wires, to avoid gaps caused to the blades. 2.On the output side, if the cuts on the wires are too deep, please check below points: Please adjust the handles on the input side, screw down or loose them. (M12 handles) Check whether the wires on the right position as you feeding them. Make sure the blades are sharp, if not, polish them with the oil stone. 3.On the output side, if see the plastic(PVC)has been stripped, but the copper wires can not been disgorged, please check below 4 points: Polish the axis of the upside with the oil stone. Check whether the springs are loose,if yes, screw down to make them tighten. The diameter of the wires are too small, please adjust the space between the two axises to 0.3-0.6mm. If the wires you want to strip are hot, also can not get the copper wires stripped out. 4.If the wires were blocked in the axises, please check below points: If the springs on the press wheels are too tight, loose them. There are too much oil on the cables/wires, please wipe it. 5.If see the blades tilted: Check whether the center adjuster was loosed. Centering adjustment and adjust the screws of two sides of it.
Make sure the wires’diameter are similar with the feeding holes,large wires in large feeding holes,small wires in small feeding holes, flat wires in flat feeding holes.