MR-J2S Series AC Servo Motor Drive MR-J2S-60A 600W 200-230VAC
MR-J2S-60A is a Drives-AC Servo
MR-J2S AC Servo Drive
Standard general-purpose AC servo
3.2A 3PH+1PH 200-230v 50Hz
3PH+1PH 200-230v 60Hz
4.8A 1PH 230v 50/60Hz
170v 0-360Hz 3.6A
We specialize in selling and servicing a wide range of products and components:
MDS and MR Series AC Servo Drives
MDS and FR Series AC Spindle Drives
FR Series General Purpose Inverters and Braking Modules
HA / HC / HF / HP / HS Series AC Servo Motors
SJ Series AC Spindle Motors
PRECAUTIONS FOR COMPLIANCE
(1) Servo amplifiers and servo motors used
Use the servo amplifiers and servo motors which comply with the standard model.
Servo amplifier series :
MR-J2S-10CL to MR-J2S-700CL
MR-J2S-10CL1 to MR-J2S40CL1
Servo motor series :
Operate the servo amplifier at or above the contamination level 2 set forth in IEC60664-1. For this purpose, install the servo amplifier in a control box which is protected against water, oil, carbon, dust, dirt, etc.
(4) Power supply
(a) Operate the servo amplifier to meet the requirements of the overvoltage category II set forth in IEC60664-1. For this purpose, a reinforced insulating transformer conforming to the IEC or EN Standard should be used in the power input section.
(b) When supplying interface power from external, use a 24VDC power supply which has been insulation-reinforced in I/O.
(a) To prevent an electric shock, always connect the protective earth (PE) terminals (marked) of the servo amplifier to the protective earth (PE) of the control box.
(b) Do not connect two ground cables to the same protective earth (PE) terminal (marked). Always connect the cables to the terminals one-to-one.
Capacitor discharge time
The capacitor discharge time is as listed below. To ensure safety, do not touch the charging section for